2014-2015 Chevrolet Camaro Z28 7.0L LS7 Whipple Supercharger Kit

2014-2015 CHEVROLET CAMARO Z/28 WHIPPLE SUPERCHARGER KIT

There are few naturally aspirated platforms as special as the Chevrolet Camaro Z/28. With its 7.0L LS7 V8, track-focused setup, and sharp throttle response, it already delivers a serious driving experience straight from the factory. Add a Whipple twin-screw supercharger system, and the result is an entirely different level of acceleration, torque, and performance throughout the RPM range.

Whipple Superchargers has been at the forefront of twin-screw supercharging technology since 1987, engineering some of the most powerful and efficient forced-induction systems in the industry. That experience carries into the Whipple system for the 2014-2015 Chevrolet Camaro Z/28, delivering substantial rear-wheel horsepower gains in a fully engineered bolt-on package designed for strong street and performance use.

At the center of the system is Whipple's front-feed W175FF 2.9L twin-screw supercharger, designed for strong airflow and immediate boost response. The twin-screw design delivers broad torque and strong power across the RPM range, helping the Camaro Z/28 gain over 180 rear-wheel horsepower on stock applications while maintaining the drivability expected from a properly developed Whipple package.

To support that level of performance, the system uses a massive air-to-water intercooler to help reduce air charge temperatures under load. The kit also includes high-flow fuel injectors, a fuel pump driver module, aluminum high-flow intake manifold, and HP Tuners RTD calibration support, giving the Z/28 a complete bolt-on supercharger solution built around the LS7 platform.

The supplied Whipple calibration is intended for stock-engine applications, and the RTD process allows PCM and TCM read capability on 2010-2015 Camaro platforms. When used as intended, the result is a substantial increase in power with strong throttle response and repeatable performance for qualifying 50-state legal applications.

Key Features:

• 50-state legal performance upgrade (CARB EO D-231-65)
• Gain over 180 RWHP on stock applications
• Front-feed W175FF 2.9L Whipple twin-screw supercharger
• Massive low-end torque and strong power throughout the RPM range
• Massive air-to-water intercooler for improved cooling capacity
• Designed to help maintain lower air charge temperatures under load
• High-flow fuel injectors included
• Fuel pump driver module included
• Aluminum high-flow intake manifold included
• HP Tuners RTD flash tool and calibration support included
• PCM and TCM read capability supported on 2010-2015 Camaro applications
• RTD support for flashing, logging, scanning, and wizard functions as applicable
• Designed for stock-engine applications
• Intended for stock or cat-back only vehicles with supplied calibration
• Long tubes, cold air intakes, cams, and big throttle bodies are not supported with the supplied calibration
• Direct bolt-on installation
• Strong street and performance drivability
• Built specifically for 2014-2015 Chevrolet Camaro Z/28 7.0L LS7 applications

Application Notes:

Whipple calibrations are intended for stock engines. Changes such as long tubes, cold air intakes, cams, and big throttle bodies are not supported with the supplied calibration. Calibration request should be completed before beginning installation.

Disclaimer: Power figures shown are based on stock applications. Individual results may vary depending on vehicle condition, fuel quality, supporting modifications, weather, and dyno type.